The principle of wire drawing machine In the production process, the continuous production of copper core wire drawing machine equipment will gradually keep pace with annealing, which will result in irregular changes in wire drawing speed, slow traction belt speed, and when the wire distance is not continuous. The factor causing this situation is the unstable support force of the storage disk.
The area where the working pressure is applied on the production line may have higher working pressure, which can lead to lower pump time of the wire drawing machine, which also makes the support force of a line unstable. However, due to the stable speed of the winding line, this makes the working pressure not stable, and it can be manipulated accurately based on a single radial error.
Damaged due to prolonged use of the main motor transmission. That can cause the speed of the traction belt and the speed of the rewinding machine to not match, resulting in wire drawing and stretching. Solution: excellent moisturizing of the battery to prevent high-speed operation of the line formed by sliding friction and anti filament; Adjust the support force of the wire, and the wire drawing time is always close to the annealing wheel; Ensure the specific annealing of the wheels and prevent surface defects of the steel from causing unstable annealing current.
According to the specific principle of the wire drawing machine, adjust the annealing wheel with adjustable triangular pulley diameter on the rotating shaft. According to the drawing principle, the annealing wheel speed ratio/electric winch speed=forward slip index × We all know that the speed ratio of the fixed speed wheel/annealing wheel diameter, electric winch wheel diameter, and annealing can be accurately measured, and the forward slip index can be obtained. The movement index of the wire drawing machine can be equipped with the mold again, so that the mold can meet the requirements.